PC-95-72 - Laserfiche WebLink

b. Remove all dirt, gravel, rubbish, refuse, and green waste from the street pavement and storm drains adjoining the site Limit construction access routes onto the site and place gravel on them Do not drive vehicles and equipment off paved or graveled areas during wet weather Broom sweep the street pavement adjoining the project site on a daily basis Scrape caked-on mud and dirt from these areas before sweeping. c. Install filter materials (such as sandbags, filter fabric, etc.) at the storm drain inlet nearest the downstream side of the project site in order to retain any debris or dirt flowing in the storm drain system Maintain and/or replace filter materials to ensure effectiveness and to prevent street flooding. d. Create a contained and covered area on the site for the storage of bags, cement, paints. oils. fertilizers. pesticides. or other materials used on the site that have the potential of being discharged into the storm drain system through being windblown or in the event of a material spill. e. Never clean machinery, equipment, tools, brushes. or rinse containers into a street, gutter, or storm drain. f Ensure that concrete/gunite supply trucks or concrete/plaster operations do not discharge wash water into street, gutters, or storm drains 90. Improvements within the creek area required by Zone 7 to stabilize the creek bank shall be shown on the plans submitted in conjunction with any tentative map. This improvements shall be consistent with the Slope Stability Evaluation prepared by Kleinfelder, dated July 31,1995. 91. The applicant shall design the on-site drainage system for the individual lots in such a manner that the storm-water runoff is filtered through a landscape area and then transported through a drain inlet to the storm drainage system in the adjacent public street. These specific details shall be submitted for review and approval of the City Engineer and Planning Director prior to approval of the final map CONDITIONS OF APPROVAL PUD-95-03 PAGE 13