PC-96-67 - Laserfiche WebLink

Resolution No. PC-96-67 Page 9 52. The applicant shall include erosion control measures on the final grading plan, subject to the approval of the City Engineer. The applicant is responsible for ensuring that the contractor is aware of such measures. All cut and fill slopes shall be revegetated and stabilized as soon as possible after completion of grading, in no case later than October 15. No grading shall occur between October 15 and April 15 unless approved erosion control measures are in place, subject to the approval of the Building Department. Such measures shall be maintained until such time as permanent landscaping is in place. 53. The developer shall submit a dust control plan or procedure as part of the improvement plans. 54. Storm drainage gutters, inlets, outfalls, and channels not within the area of a dedicated public street or public service easement approved by the City Engineer shall be privately maintained by the property owners or through an association approved by the City. 55. The design of the water supply and sanitary sewer systems shall be subject to the review and approval of the City Engineer. 56. Approval of the storm drainage system shall be subject to the review and approval of the City Engineer and Zone 7, as applicable, that the system is adequate, connects to an approved point of discharge, meets any and all applicable requirements of the Alameda County Flood Control District - Zone 7, meets any and all applicable requirements of the Federal Emergency Management Flood Hazard Program, the California Department of Fish and Game, and meets the immediate and long-range requirements of this development and all upstream areas intended to be drained through this development. 57. Electric power distribution, gas distribution, communication service, cable television, and any required alarm systems shall be installed underground in a joint utility trench unless otherwise specifically approved by the City Engineer or Director of Building Inspection for on-site 58. The applicant shall be responsible for the installation of the lighting system serving the development. The street lights shall be 70 watt, high pressure sodium vapor units mounted on galvanized steel poles with poured in place bases, on the LS-I C schedule per City requirements and P.G.&E. standard details, unless otherwise specifically approved. Approval for the number, location, and type of electroliers shall be subject to the review and approval ofthe City Engineer. 59. Any damage to existing street improvements during construction on the subject property shall be repaired to the satisfaction of the City Engineer at full expense to the developer. This shall include slurry seal, overlay, or street reconstruction if deemed warranted by the City Engineer.