PC-96-08 - Laserfiche WebLink

Resolution No. PC-96-08 Page 11 d.) Install filter materials (such as sandbags, filter fabric, etc.) at the storm drain inlet nearest the downstream side of the project site in order to retain any debris or dirt flowing into the City storm drain system. Filter materials shall be maintained and/or replaced as necessary to ensure effectiveness and to prevent street flooding. Dispose of filter particles in the trash. e.) Create a contained and covered area on the site for the storage of bags, cement, paints, flammable, oils, fertilizers, pesticides, or any other materials used on the project site that have the potential for being discharged to the storm drain system through being windblown or in the event of a material spill. f.) Never clean machinery, tools, brushes, etc., or rinse containers into a street, gutter, or storm drain. g.) Ensure that concrete/gunite supply trucks or concrete/plasterers operations do not discharge wash water into street gutters or drains. h.) Construction access routes shall be limited to those approved by the City Engineer or Building Inspector and shall be shown on the approved grading plan. 65. The applicant shall install structural control, such as an oil/water separator, sand filter, or approved equal in the parking lot to intercept and pretreat storm water prior to reaching the storm drain. The design, locations, and a schedule for maintaining the separator shall be submitted to the City Engineer/Director of Building Inspection for review and approval prior to issuance of building permits. The structural control shall be cleaned at least twice a year: once immediately prior to October I and once in January. The applicant shall enter into a maintenance agreement for the oil/water separator with the City. 66. The trash enclosure area(s) shall be completely covered. An area drain shall be installed in the enclosure area which connects to the sanitary sewer. No other area shall drain into the trash enclosure; a berm shall be installed to prevent such drainage if found necessary by the City Engineer/Director of Building Inspection. 67. The applicant shall label all on-site storm drain inlets with the wording, "No Dumping-- Drains to Bay" using City-approved methods and materials. On-site storm drain facilities shall be cleaned a minimum of twice a year as follows: immediately prior to October 15 and once in January. Additional cleaning may be required if found necessary by the City Engineer/Director of Building Inspection.