PC-2024-14 - Laserfiche WebLink

P22-1089, PUD-147, Tract 8522 PC-2024-14, June 26, 2024 27 65. STREETLIGHTS: Streetlights to be owned and maintained by the City shall include a light-emitting diode (LED) lamp and driver compliant with UL 1598. The luminaire must be dark-sky compliant with correlated color temperature (CCT) not greater than 4,000K. For safety lighting at signalized intersections, electricity for the lights shall come from a dedicated circuit fed from the traffic signal’s electrical panel. The circuit shall be controlled by a photocell that energizes the light only during nighttime hours. For free-standing streetlights on dedicated poles, the electricity shall be fed from an unmetered secondary electrical circuit provided by PG&E. A photocell on each fixture shall control operation of the lamp. Free-standing fixtures are subject to PG&E’s LS2A “Customer-owned Street and Highway Lighting” rate schedule. The applicant shall provide verification of total energy consumption of luminaire to PG&E prior to connection. Billing for LS2A electricity consumption must be transferred to the City upon acceptance of the streetlight installation. Streetlights must have an electronic type photo control meeting ANSI standard C136.10 with a turn-on value of 1.0 foot-candles and a turn off value of 1.5 foot-candles. Electro- mechanical or thermal type photo controls and not allowed. Streetlights must have badge numbers on each pole. Badge numbers must be affixed to the pole 9 feet from ground level facing the street-side and be legible from the ground. A streetlight wattage sticker needs to identify the actual total wattage consumed, be visible from the ground, be of a size and type acceptable to PG&E showing total fixture energy use in watts and must be installed on each fixture. Streetlights connected to existing joint utility poles are generally not allowed unless authorized by the City Engineer. (Address this condition prior to subdivision improvement plan approval) 66. CLEAN WATER PROGRAM (HYDROMODIFICATION PROJECTS): Because the project creates and/or replaces more than 43,560 square feet (1.00 acre) of impervious surface, increases impervious surface over pre-project conditions, and is located in a susceptible area, it is considered a Hydromodification (HM) Project according to Provision C.3.g of the Municipal Regional Stormwater NPDES Permit. Said permit regulates stormwater runoff in Pleasanton. The Alameda Countywide Clean Water Program developed a C.3 Guidance Manual to assist applicants in addressing these regulations. The Guidance Manual is available for download at: https://www.cleanwaterprogram.org/businesses/development.html HM projects must include stormwater treatment measures in the site design to cause no increase in the erosion potential of the receiving stream over the pre-project (existing) condition. To demonstrate compliance, the City encourages use of the Bay Area Docusign Envelope ID: 3D940908-F9E6-4E95-88B1-1EA134A568D0