Laserfiche WebLink
0722490 Cooling Hoses, Gates Silicone and <br />Rubber Combination - Custom <br /> <br />COOLANT LINES <br />Gates® silicone or a combination of silicone and rubber hoses will be used for the radiator and  <br />cab heater hoses installed by the chassis manufacturer. <br />The chassis manufacturer will also use Gates® brand hose on other heater and auxiliary coolant  <br />circuits. There will be some areas in which an appropriate Gates product is not available. In those <br />instances a comparable silicone hose from another manufacturer will be used. <br />Rubber hoses will be used for the overhead defrost/heater system only in the drain tubes of the <br />cab. <br />Hose clamps will be stainless steel constant torque type to prevent coolant leakage. They will <br />react to temperature changes in the cooling system and expand or contract accordingly while <br />maintaining a constant clamping pressure on the hose. <br />0755683 SP Fuel Tank, 50 Gallon, Left Side Fill, <br />w/ Air Suspension, Aluminum <br /> <br />FUEL TANK <br />A 50 gallon fuel tank will be provided and mounted at the rear of the chassis. The tank will be <br />constructed of aluminum with the exterior painted to match the chassis frame It will be equipped <br />with swash partitions and a vent. To eliminate the effects of corrosion, the fuel tank will be <br />mounted with stainless steel straps. <br />A .75" drain plug will be located in a low point of the tank for drainage. <br />A fill inlet will be located on the left hand side of the body and is covered with a hinged, spring <br />loaded, stainless steel door that is marked "Ultra Low Sulfur - Diesel Fuel Only." <br />A .50" diameter vent will be installed from tank top to just below fuel fill inlet. <br />The fuel tank will meet all FHWA 393.67 requirements, including a fill capacity of 95 percent of <br />tank volume. <br />0001129 Lines, Fuel All fuel lines will be provided as recommended by the engine manufacturer. <br />0733463 SP DEF Tank, 6.0 Gallon, LS Fill, Rear <br />of Axle, Common Door, Paccar <br /> <br />DIESEL EXHAUST FLUID TANK <br />A 6.0 gallon diesel exhaust fluid (DEF) tank will be provided and mounted in the driver's side <br />body rearward of the rear axle. <br />A fill inlet will be provided and marked "Diesel Exhaust Fluid Only". The fill inlet will be located <br />adjacent to the engine fuel inlet behind a common hinged, spring loaded, polished stainless steel <br />door on the driver side of the vehicle. <br />The selector flap within the common area for the fuel and DEF fills will have a flush lift & turn <br />latch. The latch will be provided so that the selector flap will be latched when the flap is in the <br />position over the DEF fill. <br />The tank will meet the engine manufacturers requirement for 10 percent expansion space in the <br />event of tank freezing. <br />The tank will include an integrated heater unit that utilizes engine coolant to thaw the DEF in the <br />event of freezing. <br />0552793 Not Required, Fuel Priming Pump <br /> <br />0552712 Not Required, Shutoff Valve, Fuel <br />Line <br />0699437 Cooler, Chassis Fuel, Not Req'd. <br /> <br />0690880 No Selection Required From This <br />Category <br />  <br />0887546 Trans, Allison 6th Gen, 4000 EVS P, <br />w/Prognostics, Imp/Vel/SFR/Enf <br /> <br />TRANSMISSION <br />An Allison 6th generation, Model EVS 4000P, electronic, torque converting, automatic <br />transmission will be provided. <br />The transmission will be equipped with prognostics to monitor oil life, filter life, and transmission <br />health. A wrench icon on the shift selector's digital display will indicate when service is due. <br />Two (2) PTO openings will be located on left side and top of converter housing (positions 8 <br />o'clock and 1 o'clock). <br />A transmission temperature gauge with an amber light and buzzer will be installed on the cab <br />instrument panel. <br />10717Bid #: