12 - Laserfiche WebLink

3.3.11.Two (2) 13,500 BTU low-profile heat pump air conditioners shall be installed per drawings. 3.3.11.1. Units shall provide 13,500 BTUs of cooling 3.3.11.2. Units shall include self-contained, low-profile ceiling assembly with remote control 3.3.11.3. Units shall stand a maximum of 10" above the roof and be included in the overall height measurement. 3.3.11.4. These units shall be powered by a non-inverted circuits but be connected to the auto generator start(AGS)system. 3.3.12.One (1) 55" high-resolution LCD monitor shall be installed in the exterior compartment on the curb side of the vehicle. 3.3.12.1. Unit shall be shock-mounted, but easily removable for service and/or replacement. 3.3.12.2. Unit shall feature a1000 Nit screen brightness(minimum), and a 16:9 widescreen display. 3.3.12.3. Unit shall be capable of playing content via USB and include one (1) HDMI cable run from the front desk. 3.3.12.4. Unit shall be powered through the inverter. 3.3.13.One(1) Bose Solo 5 or equivalent sound bar shall be provided and mounted below the exterior screen to enhance audio broadcast. 3.4. Electrical System — DC/Other 3.4.1. Shall be a 12-volt, negative ground type system designed to provide and distribute electrical power at a level of performance that meets the requirements of all components and/or accessories utilizing such power throughout the vehicle. 3.4.1.1. Design emphasis of system furnished shall be on both reliability and serviceability. System furnished shall be a modular type design, modular being defined as a system where major power train,chassis, body component assemblies, including lighting, wiring and switch harnesses, and heater harnesses are easily separable for purposes of repair or replacement, using either simple hand tool or automotive type plug-in connectors. Special emphasis shall be made on accessibility to all wiring harnesses in all locations. Wiring shall not be rendered un-accessible behind permanently installed panels or appointments. 3.4.1.2. The power source for all body electrical equipment furnished shall be taken from a single point on the power train specifically designed for this purpose. 3.4.1.3. The main ground wire grounding the body to the chassis shall be minimum 8-gauge size; all ground wires furnished for insulated-return type systems shall be equal in size to the feed wire in the respective circuit. Redundant City of Pleasanton Outreach Vehicle Specifications(Version 1.1) Page 18 of 23