RES 221331 - Laserfiche WebLink

ATTACHMENT I—NOTICE TO PROCEED FOR I PROPERTY#1 [buert PP" j 1. Site Description The Site shall include(add written descriptionj. [include map designating Site on Propertyj 11. Charging Stall Description [Example: EBCE plans to install 10-150 kilowatt dual port direct current fast chargers ("DCFC') in 20 Charging Stalls at the Property. Each DCFC will be capable of powering 2 Charging Stalls. Please note, the capacity of the DCFC equipment may change in the.f nal project design. Per State of California requirements, 2 of the Charging Stalls will comply with the Americans With Disabilities Act ("ADA'). To accommodate the van accessible ADA requirements, and DCFC equipment requirements generally based on final product selection, 2 additional parking spaces may be needed at the Property (for a total of up to 24 parking spaces). To accommodate the electrical load of 10 DCFCs at the Property, EBCE will bring in a new PG&E metering service at a 2-megawatt maximum size. EBCE costs related to the new electrical service will be assumed by EBCE. The electrical service that powers the Charging Stalls will be EBCE's Renewable 100 electricity product and EBCE will be responsible for the meter. The Host will not pay any costs associated with the electricity consumption from this new meter.A new transformer room will be constructed in an area of the southwest corner of Level 1 of the Property. The transformer room will house the required PG&E transformer. EBCE will coordinate with PG&E through their Service Planning process, and the City Representative, to confirm this location. A 3000 Amp switchboard would be in the southwest corner of parking Level 1 as well. EBCE will seek the procurement oj'turnkey services from a single vendor, to be selected through a Public Works Bid Specification solicitation issued by EBCE, that includes final design, equipment, installation, load management system, ongoing maintenance services, and back-office services (e.g., communications, user account management, billing, reporting, utility interface application, etc.). The vendor will be under contract with EBCE and will: • Construct the new transformer room and install the new transformer in coordination with PG&E and EBCE • Install all associated wiring and conduit that enable the operation of the Charging Stalls (following all applicable building codes, industry standards, and best practices) • Be responsible for pouring the concrete pads on which the DCFCs will be installed and designing and installing appropriate physical barriers (barrier posts, wheel stops)for structural support and protection of the DCFCs • Mount all equipment in front of the Charging Stalls and will take into consideration accessibility to cables and plugs as well as connectivity to vehicles • Be required to incorporate cable management systems in each Charging Stall to keep the charging cables off the ground • Ensure the installation of the DCFCs complies with ADA requirements • Re-stripe the Charging Stalls as needed • Provide all signage required in consultation with EBCE • Procure DCFCs and incorporate load management systems • Provide a credit card payment solution (i.e. kiosk) if the DCFCs procured do not have a built-in credit card reader to ensure compliance with SB 454 12