2_Exhibits A-E - Laserfiche WebLink

PUD-145 Planning Commission Page 3 of 17 13. WINDOWS: Manufacturer type, design, material, and installation details for all windows within the project shall be specified for each unit/building in conformance with the Approved Plans in the building permit submittal. Any proposed modifications shall be subject to review and approval by the Planning Division prior to issuance of building permits. 14. FENCE/WALL: All fencing and walls shall be shown on the construction plans with the building permit submittal. The design and location must be approved by the Planning Division and comply with all setback requirements. 15. LIGHTING PLAN: The applicant shall submit a lighting plan with the building permit submittal. The plan shall include photometric contours, manufacturer’s specifications on the fixtures, and mounting heights. All exterior lighting including landscape lighting shall be directed downward and designed or shielded so as to not shine onto neighboring properties or streets. The photometrics shall be reviewed and approved by the City Traffic Engineer and Director of Community Development prior to building permit issuance. The type and location of all exterior light fixtures shall be reviewed and approved by the Director of Community Development prior to building permit issuance. 16. BUILDING SURVEY: The applicant shall submit a building survey and/or record of survey and a site development plan in accordance with the provisions of Chapter 18.68 of the PMC. These plans shall be approved by the Chief Building Official prior to building permit issuance. The site development plan shall include all required information to design and construct site, grading, paving, drainage, and utilities. 17. PAD AND SETBACK CERTIFICATION: The applicant shall submit a pad elevation certification prepared by a California licensed land surveyor or registered civil engineer to the Chief Building Official and Director of Community Development certifying the pad elevations and building locations (setbacks) are conforming to the approved plans, prior to receiving a foundation inspection for the structures. 18. BUILDING HEIGHT CERTIFICATION: The applicant shall submit a building height certification prepared by a California licensed land surveyor or civil engineer to the Director of Community Development before the first framing or structural inspection by the Building and Safety Division. The height of the structures shall be surveyed and verified as being in conformance to the approved building heights as shown on Exhibit B or as otherwise conditioned. 19. FINAL INSPECTION: Final inspection by the Planning Division is required prior to occupancy. 20. FIREPLACES AND FIRE PITS: Fireplaces and fire pits shall be gas fireplaces, pellet fueled wood heaters, or EPA certified wood-burning appliances. The fireplace types shall be indicated on the plan and/or specification sheet(s) submitted to for issuance of building permits. Green Building and Sustainability Measures 21. PHOTOVOLTAIC AND SOLAR WATER HEATING SYSTEMS: The new residence shall be constructed to allow for future installation of a photovoltaic (PV) system and a solar water heating system. The measures shall be shown on the building permit plans for review and approval by the Director of Community Development prior to building permit issuance. The applicant shall provide the future owners the necessary information delineating the means by which photovoltaic panels can be applied to the roof of the new structure covered by this approval. This information shall be reviewed and approved by the Director of Community Development prior to occupancy of the unit. The applicant shall comply with the following requirements for making the new dwelling unit on the subject site photovoltaic-ready and solar water heating-ready: