07 - Laserfiche WebLink

Attachment 1 Exhibit B water-heating equipment efficiency. Wall and concealed ceiling insulation inspections are required to be made after the frame inspection is approved and before being covered. 9. Lath and/or wallboard Inspection. Lath and gypsum board inspections shall be made after lathing and gypsum board, interior and exterior, is in place,but before any plastering is applied or gypsum board joints and fasteners are taped and finished. EXCEPTION: Gypsum board that is not part of a fire-resistance-rated assembly. 10. Fire-resistance-rated Construction Inspection. Wherever fire-resistance-rated construction is required,the Building and Safety Official shall require an inspection of such construction after all lathing and/or wallboard is in place,but before any plaster is applied,or before wallboard joints and fasteners are taped and finished. Protection of joints and penetrations in fire-resistance-rated assemblies, smoke barriers and smoke partitions shall not be concealed from view until inspected and approved. 11. Weather-exposed balcony and walking surface waterproofing. Where balconies or other elevated walking surfaces are exposed to water from direct or blowing rain, snow or irrigation, and the structural framing is protected by an impervious moisture barrier,all elements of the impervious moisture barrier system shall not be concealed until inspected and approved. EXCEPTION: Where special inspections are provided in accordance with California Building Code Section 1705.1.1, Item 3. 12. Other Inspections. In addition to the inspections specified above,the Building and Safety Official is authorized to make or require other inspections of any construction work to ascertain compliance with the provisions of this code and other laws that are enforced by the department of building safety. 13. Final Inspection. Final inspection shall be made after the permitted work is complete and prior to occupancy. Page 10 of 60