04 - Laserfiche WebLink

OrdinanceNo.2203 Page 23 weight of 70,000 pounds under=al,l weather conditions.Unobstructed width shall notinclude the width of rolled curbs, sidewalks, or non-drivable surfaces. All exterior portions of buildings must be within 200 feet,ofan,access road. Yard and parking area may be able to be located farther than 200 feet from access roads, depending on the specific use. 91. FIRE VEHICLE TURNAROUNDS: Where.Fire Department vehicle access: through or around a site involves..changes=in direction or curves, inside radius of 45 feet and outside radius of 55 feet shall be provided to facilitate fire truck turning radius for entry and exit from the site. Dead-end access'ways and internal drives shall not exceed 300 feet in length andishall terminate in cul-de-sacs no less than 96 feet in diameter or hammer-head (tee). Standards and options are available through the Livermore-Pleasanton Fire Department, Fire Prevention Bureau. - i 92. PREMISES IDENTIFICATION: Address numbers shall be installed on the front or primary entrance for all buildings. Minimum building.address character size shall be 12-inch high by 1-inch stroke. In all cases.,address.numerals shall be of contrasting backgroundandclearly-visible in accordance with'the Livermore- Pleasanton Fire,Department Premises Identification Standards..:This may warrant field verification and adjustments based,upon itopography, landscapingor other obstructions: 93. COMMERCIAL — NEW CONSTRUCTION: Thle following items shall be provided prior to any construction above the foundation', orslab. a. Emergency vehicle access shall beiprovided to the site, including areas where construction is occurring..If Public Works Improvements are part of the project.to,access the;site,-an emergency vehicle access plan.shall be submitted,for.review and approval to the Fire Department. b. If permanent access or site paving its not provided, the carrying capacity of the emergency vehicle access shall be 70,000pounds under all weather conditions. c. Site staging area(s) shall be provided for materials and equipment. All staging areas shall be outside of the emergency vehicle access route shown on the approved plans. - d. Where on-site fire hydrant(s) are required, they shall be installed, flushed and all valves open prior to any construction above the foundation or slab. This includes concrete tilt-up and-masonry buildings. e. On-site fire hydrant(s) shall not be obstructed and shall be sufficiently above grade to have all hydrant valves and outlets accessible for emergency use. . f. Where a project is phased as part of the development, specific access, water supply and fire hydrant installations will be required as part of ,each phase. As needed a phasing plan with these improvements will be required.