PC-2019-20 - Laserfiche WebLink

applicant shall install two reduced pressure backflow devices, one at the domestic water meter(s) and one at the existing water well(s) to remain, on all lots where the existing water well is to remain. 62. SANITARY SEWER CONNECTIONS: The applicant shall provide each lot, parcel of land, or building with an independent connection to the public sanitary sewer main as provided for in the Municipal Code. 63. SANITARY SEWER DEMAND CALCULATIONS: The applicant's California licensed civil engineer shall submit sanitary sewer demand calculations for the development with the first submittal of the building permit or improvement plans, whichever occurs first. 64. WATER LATERALS: The applicant shall provide each lot, parcel of land, or building with an independent connection to the public water main as provided for in the municipal Code. 65. WATER AND SEWER CAPACITY: This approval does not guarantee the availability of sufficient water and/or sewer capacity to serve the project. Recordation of a parcel/final map, issuance of a grading permit, issuance of a building permit, or utility extension approval to the site, shall not occur until the Engineering Department verifies sufficient water and/or sewer is available for the project. If sufficient water and/or sewer is not available, the applicant may need to offset the project's demand. 66. EXISTING WATER METERS: The applicant's California licensed civil engineer shall depict existing water meters on the improvement plans including their size, flow rate and serial numbers. 67. WATER METERS (RESIDENTIAL): The applicant shall provide a water meter to each lot of record within the development unless otherwise approved by the Director of Engineering/City Engineer. 68. JOINT UTILITY TRENCH: All dry utilities (electric power distribution, gas distribution, communication service, cable television, street lights and alarm systems) required to serve an existing or new development shall be installed in underground conduit in a joint utility trench subject to the review and approval of the Director of Engineering/City Engineer and prior to City council acceptance of public improvements. 69. PUBLIC SERVICE EASEMENT: The applicant shall grant a public service easement (PSE) to the City over those parcels and lots as determined by and subject to the review and approval of the Director of Engineering/City Engineer and prior to City Council acceptance of public improvements. 70. PRIVATE EASEMENTS: The applicant shall record private access, drainage, and utility easements across the project for the benefit of the individual lots as determined by, subject to the review and approval by, and at a time determined by the Director of Engineering/City Engineer. 71. UTILITY VAULTS: The applicant shall set existing and proposed utility vaults to the grade of adjacent curb and/or sidewalk as determined by and subject to the review and approval of the Director of Engineering/City Engineer and prior to City Council acceptance of public improvements. Subdivisions 72. MAINTENANCE OF COMMON IMPROVEMENTS: All common improvements including but not limited to storm drainage swales, gutters, inlets, outfalls, channels, retaining walls, soundwalls, PUD-133 Planning Commission Page 11 of 18 he Engineering Department in writing of Zone 7's desire to retain any water well concurrently with the first plan check of the improvement plans. The applicant shall submit a written request to the Director of Engineering/City Engineer for approval for the temporary use of an existing water well(s) for construction water or for permanent use such as non-potable outdoor landscaping irrigation. The PUD-133 Planning Commission Page 10 of 18 ent, grading, or subdivision permit, whichever occurs first. 54. GEOTECHNICAL CONSULTANT — CERTIFICATION OF CONSTRUCTION OF SUBDIVISIONS: The applicant's California licensed geotechnical engineer shall inspect and approve the PUD-133 Planning Commission Page 9 of 18