PC-99-52 - Laserfiche WebLink

Resolution No. PC-99-52 Page 10 BUILDING 50. The garage and dwelling unit above the garage shall be constructed to meet Title 24 state energy requirements. 51. All building and/or structural plans must comply with all codes and ordinances in effect before the Building Department will issue permits. 52. The applicant shall submit a building survey and/or record of survey and a site development plan in accordance with the provisions of Chapter 18.68 of the Municipal Code of the City of Pleasanton. These plans shall be approved by the Director of Building Inspection prior to the issuance of a building permit. The site development plan shall include all required information to design and construct site, grading, paving, drainage, and utilities. Specific items to be indicated on the site development plan necessary to construct the improvements are to be in accordance with the City of Pleasanton Private Development Design Guidelines adopted April 15, 1986. 53. The paving sections for the on-site parking and drive areas shall be designed on the basis of an R-Value test and a traffic index to carry the anticipated traffic loads. This design shall be subject to the approval of the Director of Building Inspection. The minimum paving section shall be 2" A.C. on 6" of A.B. The minimum A.C. pavement slope shall be 1%. For pavement slopes of less than 1%, the surface runoff shall be carried in a concrete gutter to an acceptable point of discharge. The minimum slope for concrete gutter shall be 0.5%. 54. A sanitary sewer sampling manhole shall be provided on each of the sanitary sewer lateral from each building, unless otherwise waived by the Director of Building Inspection. 55. Prior to issuance of a building permit, the applicant shall pay the applicable Zone 7 and City connection fees and water meter cost for any water meters, including irrigation meters. Additionally, the developer shall pay any applicable DSRSD sewer permit fee. 56. The applicant shall submit a plot plan for the lot showing building setbacks and a topographic plan showing grading and drainage. Pad elevations, finish floor elevations, retaining walls, easements, and maximum height of the highest structure are to be indicated on the plan. All residential plot plans shall show compliance with 2907(d) and 70012(d) of the Uniform Building Code.