ORD 2155 - Laserfiche WebLink

• bearing no advertising message,may be installed with the approval of the zoning administrator, if necessary, in order to facilitate traffic circulation,or if the facility is not visible from the public right-of-way;and m. Power-driven processing, including aluminum foil and can compacting, baling, plastic shredding, or other light processing activities necessary for efficient temporary storage and shipment of material, may be allowed by the planning commission as part of the conditional use permit review and approval process if noise and other conditions are met. 4. Recycling Processing Facilities. Large and small recycling processing facilities are permitted in the I-G (general industrial) zoning district with approval of a conditional use permit. Processing facilities must meet the fol- lowing conditions: a. Facility does not abut a property zoned or planned for residential use; b. Processors will operate in a wholly enclosed building(except for incidental storage)or: 1. Within an area enclosed on all sides by an opaque fence or wall not less than eight feet in height and land- scaped on all street frontages, and 2. Located at least 150 feet from property zoned or planned for residential use; c. Power-driven processing shall be permitted, provided that all noise level requirements are met. Small recy- cling processing facilities are limited to baling, briquetting, crushing, compacting, grinding, shredding and sorting of source-separated recyclable materials and repairing of reusable materials; d. A small recycling processing facility shall be no larger than 45,000 square feet and shall have no more than an average of two outbound truck shipments of material per day and may not shred, compact or bale ferrous metals other than food and beverage containers; e. A processing facility may accept used motor oil for recycling from the generator in accordance with Sec- tion 25250.11 of the California Health and Safety Code; f. Setbacks and landscaping requirements shall be those of the I-G zoning district; g. All exterior storage of material shall be in sturdy containers or enclosures which are covered,secured, and maintained in good condition. Storage containers for flammable material shall be constructed of nonflammable materi- als. Oil storage must be in containers approved by the city hazardous materials specialist. No storage, excluding truck trailers and overseas containers,will be visible above the height of the fencing; h. Site shall be maintained free of litter and any other undesirable materials, and will be cleaned of loose de- bris on a daily basis and will be secured from unauthorized entry and removal of materials when attendants are not pre- sent; i. Space shall be provided on site for the anticipated peak load of customers to circulate, park and deposit recyclable materials. If the facility is open to the public, space will be provided for a minimum of 10 customers or the peak load, whichever is higher, except where the planning commission determines that allowing overflow traffic is compatible with surrounding businesses and public safety; j. One parking space will be provided for each commercial vehicle operated by the processing center. Parking requirements will otherwise be as mandated by the zoning district in which the facility is located; k. Noise levels shall not exceed 60 dBA as measured at the property line of residentially zoned or occupied property; 1. If the facility is located within 500 feet of property zoned or planned for residential use, it shall not be in operation between seven p.m. and seven a.m. The facility will be administered by on-site personnel during the hours the facility is open; m. Any containers provided for after-hours donation of recyclable materials will be at least 50 feet from any property zoned or occupied for residential use; shall be of sturdy, rustproof construction; shall have sufficient capacity to accommodate materials collected and shall be secure from unauthorized entry or removal of materials; n. Donation areas shall be kept free of liner and any other undesirable material. The containers shall be clearly marked to identify the type of material that may be deposited. The facility shall display a notice stating that no material shall be left outside the recycling containers; o. Sign requirements shall be those of the I-G zoning district. In addition, the facility shall be clearly marked with the name and phone number of the facility operator and the hours of operation; and p. No dust, fumes, smoke vibration or odor above ambient level may be detectable on neighboring properties. (Ord. 2000 § 1,2009;Ord. 1354 § 1, 1988) [No changes proposed to Sections 9.22.010, 9.22.010, and 9.22.0501 6