04 - Laserfiche WebLink

G. To provide sufficient open space around industrial structures to protect them from the hazard of fire and to mini- mize the impact of industrial plants on nearby residential and agricultural districts; H. To minimize traffic congestion and to avoid the overloading of utilities by preventing the construction of build- ings of excessive size in relation to the amount of land around them. (Prior code §2-7.17) 18.48.020 Special purpose-1-P industrial park district. The special purposes of the I-P district are as follows: A. To establish and maintain high standards of site planning, architecture and landscape design that will create an environment attractive to the most discriminating industries and research and development establishments seek- ing sites in northern California; B. To provide locations for industries that can operate in close proximity to commercial and residential uses with minimum mutual adverse impact; C. To protect light industrial and related uses from nuisances associated with heavy industrial uses. (Prior code § 2- 7.18) 18.48.030 Special purpose-1-G general industrial district. The special purpose of the I-G district is to provide locations where industries that are incompatible with most other land uses can operate with minimum restriction and without adverse effect on other uses. (Prior code §2-7.18(a)) •. 18.48.050040 Required conditions generally. All uses shall comply with the regulations prescribed in Chapter 18.84 of this title and with the additional regulations prescribed in this section. The zoning administrator may require submission of evidence of ability to comply with the required conditions or of maintenance of the required conditions as prescribed in Chapter 18.128 of this title regarding determination of compliance with required conditions. (Prior code §2-7.19) 18.48.060050 Noise restrictions. In an I-P or L I district,no use except a temporary construction operation shall be permitted which creates,at any point beyond the boundaries of the site, noise of a maximum sound pressure level greater than the values given in the follow- ing table. In an I-G district no use except a temporary construction operation shall be permitted which creates, at any R or 0 district boundary, noise of a maximum sound pressure level greater than the values given in the following table. The sound pressure levels shall be measured in decibels 0.002 dynes per square centimeter with a sound level meter and associated octave band filter conforming to standards prescribed by the American Standards Association. 56