07 - Laserfiche WebLink

c. All field- testing and inspection of piping joints shall be conducted prior to covering of any pipeline. 132. Dead -end fire service water mains shall not exceed 500 feet in length and /or have more than five Fire Department appliances* shall be looped around the site or building and have a minimum of two points of water supply or street connection. Zone valves shall be installed as recommended under NFPA, Pamphlet 24 and the Fire Marshal. *Note: Fire Department appliances are classified as fire sprinkler system risers, fire hydrants and /or standpipes. 133. Portable fire extinguisher(s) shall be provided and installed in accordance with the California Fire Code currently in effect and Fire Code Standard #10 -1. Minimum approved size for all portable fire extinguishers shall be 2A 10B:C. 134. All buildings undergoing construction, alteration or demolition shall comply with Chapter 14 (California Fire Code currently in effect) pertaining to the use of any hazardous materials, flame- producing devices, asphalt/tar kettles, etc. 135. The building (s) covered by this approval shall conform to the requirements of the California Building Code currently in effect, the California Fire Code currently in effect and the City of Pleasanton Ordinance 2015. If required plans and specifications for the automatic fire sprinkler system shall be submitted to the Livermore - Pleasanton Fire Department for review and approval prior to installation. The fire alarm system, including water flow and valve tamper, shall have plans and specifications submitted to Fire Prevention for review and approval prior to installation. All required inspections and witnessing of tests shall be completed prior to final inspection and occupancy of the building(s). URBAN STORMWATER CONDITIONS 136. The project developer shall include erosion control measures, prepared and signed by the Qualified Storm Water Pollution Prevention Plan Developer (QSD), on the final grading plan, subject to the review of the City Engineer. These erosion control measures shall be as required by the state's Construction General Permit. The project developer is responsible for ensuring that the contractor is aware of such measures. All cut and fill slopes shall be revegetated and stabilized as soon as possible after completion of grading, in no case later than October 15. No grading shall occur between October 15 and April 15 unless approved erosion control measures are in place, subject to the approval of the project QSD and the City Engineer. Such measures shall be maintained until such time as a permanent landscaping is in place, site is stabilized and Notice of Completion (NOC) has been filed with the State Regional Water Board and /or accepted by City. P16 -1201, P16 -1202 & PUD -120, Catalyst Development City Council Page 23 of 30