Laserfiche WebLink
replace filter materials to ensure effectiveness and to prevent street <br /> flooding. <br /> f) Create a contained and covered area on the site for the storage of <br /> cement, paints, oils, fertilizers, pesticides, or other materials used on the <br /> site that have the potential of being discharged into the storm drain system <br /> through being windblown or in the event of a material spill. <br /> g) Never clean machinery, equipment, tools, brushes, or rinse containers into <br /> a street, gutter, or storm drain. <br /> h) Ensure that concrete/gunite supply trucks or concrete/plaster operations <br /> do not discharge wash water into street, gutters, or storm drains. <br /> i) Equipment fueling area: Use off-site fueling stations as much as possible. <br /> Where on-site fueling occurs, use designated areas away from the storm <br /> drainage facility, use secondary containment and spill rags when fueling, <br /> discourage "topping off' of fuel tanks, place a stockpile of absorbent <br /> material where it will be readily accessible, and check vehicles and <br /> equipment regularly for leaking oils and fuels. Dispose rags and absorbent <br /> materials promptly and properly. <br /> j) Concrete wash area: Locate wash out areas away from the storm drains <br /> and open ditches, construct a temporary pit large enough to store the <br /> liquid and solid waste, clean pit by allowing concrete to set, breaking up <br /> the concrete, then recycling or disposing of properly. <br /> k) Equipment and vehicle maintenance area: Use off-site repair shop as <br /> much as possible. For on-site maintenance, use designated areas away <br /> from the storm drainage facility. Always use secondary containment and <br /> keep stockpile of cleanup materials nearby. Regularly inspect vehicles and <br /> equipment for leaks and repair quickly or remove from the project site. <br /> Train employees on spill cleanup procedures. <br /> C. Operation Requirements <br /> The Permit's operation and maintenance requirements include but are not limited <br /> to the following: The operation and maintenance of treatment measures including <br /> but not limited to bio-swales, lawns, landscaped areas with deep-rooted plants, <br /> oil/water separator, filterra units, etc., requires completing, signing and recording <br /> an agreement with Alameda County recorder's office in a format approved by the <br /> State and Alameda County. <br /> 1. All projects, unless otherwise determined by the City Engineer or Chief <br /> Building Official, shall enter into a recorded Stormwater Treatment Measures <br /> Inspection and Maintenance Agreement for ongoing maintenance and <br /> 26 of 28 <br />