04 - Laserfiche WebLink

the City Engineer, or other easements, which may be designated by the City Engineer. 98. The applicant/project developer shall construct vertical P.C.C. curbs and gutters within this development unless otherwise approved by the City Engineer. When the sidewalk is adjacent to the curb and gutter, they shall be poured monolithically. 99. All existing septic tanks or holding tanks shall be properly abandoned, pursuant to the requirements of the Alameda County Department of Health Services prior to the start of grading operations, unless specifically approved by the City Engineer. 100. The haul route for all materials to and from this development shall be approved by the City Engineer prior to the issuance of a permit, and shall address the need to schedule major truck trips and deliveries during off peak travel times, to avoid peak travel congestion. It shall also include the provision to monitor the street surfaces used for the haul route so that any damage and debris attributable to the haul trucks is identified and corrected at the expense of the project applicant or developer. 101. All dry utilities (electric power distribution, gas distribution, communication service, cable television, street lights and any required alarm systems) required to serve existing or new development shall be installed in conduit, underground in a joint utility trench unless otherwise specifically approved by the City Engineer. 102. This approval does not guarantee the availability of sufficient water and/or sewer capacity to serve the project. 103. There shall be no direct roof leaders connected to the street gutter or storm drain system, unless otherwise approved by the City Engineer. 104. The applicant/project developer's contractor(s) shall obtain an encroachment permit from the City Engineer prior to moving any construction equipment onto the site. 105. The applicant/project developer shall submit a final grading and drainage plan prepared by a licensed civil engineer depicting all final grades and drainage control measures, including concrete-lined V-ditches, to protect all cut and fill slopes from surface water overflow. This plan shall be subject to the review and approval of the City Engineer prior to the issuance of a subdivision grading permit. 106. The applicant/project developer shall include erosion control measures on the final grading plan, subject to the approval of the City Engineer. The project developer is responsible for ensuring that the contractor is aware of such measures. All cut and fill slopes shall be revegetated and stabilized as soon as possible after completion of grading, in no case later than October 15. No grading shall occur between October 15 and April 15 unless approved erosion control measures are in place, 17 of 28