RES 16834 - Laserfiche WebLink

Ordinance No.16-834 Exhibit A 98. The project applicant or developer shall be responsible for the installation of the street lighting system serving the development. The street lights shall be LED units mounted on galvanized steel poles with poured in place bases, on the LS- 1C schedule per City requirements and PG&E standard details, unless otherwise specifically approved. The lighting system design shall conform to the Illuminating Engineering Society (IES). Approval for the number, location, and type of electroliers shall be subject to the review and approval of the City Engineer. 99. All retaining walls along the street shall be placed behind the Public Service • Easement (PSE), unless otherwise approved by the City Engineer. 100. The project applicant or developer shall submit a final grading and drainage plan prepared by a licensed civil engineer depicting the final grades and drainage control measures, including concrete-lined V-ditches, to protect all cut-and-fill slopes from surface water overflow. All supporting information and design criteria (including but not limited to any peer review comments), storm drain treatment calculations, hydromodification worksheets, etc., shall be submitted as part of the improvement plans. This plan shall be subject to the review and approval of the City Engineer prior to the issuance of a subdivision grading permit. 101. The project developer shall submit detailed landscape and irrigation plans as part of the improvement plans. The irrigation plan shall provide for automatic controls. 102. The project developer shall be responsible for the undergrounding of the overhead utility fines across the project frontage. All utility lines shall be installed in conduit. Only PG&E switch enclosures or capacity banks can be installed above ground provided the units are screened with landscaping to the satisfaction of the Director of Community Development. 103. The improvement plans for this development shall contain signage and striping plans that are subject to the approval of the City Traffic Engineer. 104. The minimum grade for the gutter flow line shall be set at one percent where practical, but not less than 0.75% unless otherwise approved by the City Engineer. • 105. The curb and gutter along the street shall have a sub drain installed at either the back of the curb or lip of gutter at the discretion of the City Engineer. This detail shall be shown on the improvement plans. Said drains shall be connected to the storm drain system or drained by other means acceptable to the City Engineer. 106. A water meter shall be provided to each lot of record within the development. Page 19 of 31