06 - Laserfiche WebLink

52. The applicant/building developer shall submit a final list of the green building measures used in the design of the residential units covered by this approval to the Planning Division for the review and approval by the Director of Community Development prior to the building permit submittal. The residential units shall be designed to achieve a "certified rating" of a minimum of 50 total points, achieving at least the minimum points in each category, using BuildltGreen's current GreenPoints rating system. Notwithstanding the foregoing, the State of California's Green Building Standards Code, "CALGreen", as amended, shall also apply. a. The green building measures shall be shown on one of the first two pages of the plans submitted for issuance of a building permit. Each point identified shall have a notation indicating the sheet the point can be found, and each sheet shall note where the point is located. All proposed green building measures shall be shown throughout the plan set, as appropriate, as determined by the Director of Community Development. b. A special inspection by from the Planning Division shall be coordinated with regards to landscaping, irrigation, and exterior materials. All of the green building measures indicated on the approved checklist shall be inspected and approved by either the City of Pleasanton, a third party rater, or the applicants shall provide written verification by the project engineer, architect, landscape architect, or designer. 53. The residential units shall be constructed to allow for future installation of a Photovoltaic (PV) system and solar water heating systems. The new commercial/office building shall also be constructed to allow for future installation of a Photovoltaic (PV) system. The project applicant shall comply with the following requirements for making the dwellings and commercial/office building photovoltaic-ready and/or solar-water-heating-ready: a. Electrical conduit and cable pull strings shall be installed from the roof/attic area to the building's main electrical panels; b. An area shall be provided near the electrical panel for the installation of an "inverter" required to convert the direct current output from the photovoltaic panels to alternating current; c. Engineer the roof trusses to handle an additional load as determined by a structural engineer to accommodate the additional weight of a prototypical photovoltaic system beyond that anticipated for roofing. d. Plumbing shall be installed for solar-water heating; and e. Space shall be provided for solar-heating tank. These measures shall be shown on the building permit plan set submitted to the Director of Community Development for review and approval before issuance of the first building permit. PUD-109, 273 Spring Street Planning Commission Page 8 of 22