01 - Laserfiche WebLink

hydroseeding, hay bales, sandbags, and siltation fences and are subject to the review and approval of the City Engineer/Chief Building and Safety Official. If no grading plan is required, necessary erosion control/ stormwater quality measures shall be shown on the site plan submitted for an on-site permit, subject to the review and approval of the Building and Safety Division. The project applicant or developer is responsible for ensuring that the contractor is aware of and implements such measures. b. All cut-and-fill slopes shall be revegetated and stabilized after completion of grading, but in no case later than October 15. Hydroseeding shall be accomplished before September 15 and irrigated with a temporary irrigation system to ensure that the grasses are established before October 15. No grading shall occur between October 15 and April 15 unless approved erosion control/stormwater quality measures are in place, subject to the approval of City Engineer/Chief Building and Safety Official. Such measures shall be maintained until such time as permanent landscaping is place. c. Gather all sorted construction debris on a regular basis and place it in the appropriate container for recycling; to be emptied at least on a weekly basis. When appropriate, use tarps on the ground to collect fallen debris or splatters that could contribute to stormwater runoff pollution. d. Remove all dirt, gravel, rubbish, refuse, and green waste from the street pavement and storm drains adjoining the site. Limit construction access routes onto the site and place gravel on them. Do not drive vehicles and equipment off paved or graveled areas during wet weather. Broom sweep the street pavement adjoining the project site on a daily basis. Scrape caked-on mud and dirt from these areas before sweeping. e. Install filter materials (such as sandbags, filter fabric, etc.) at the storm drain inlet nearest the downstream side of the project site in order to retain any debris or dirt flowing in the storm drain system. Maintain and/or replace filter materials to ensure effectiveness and to prevent street flooding. f. Create a contained and covered area on the site for the storage of cement, paints, oils, fertilizers, pesticides, or other materials used on the site that have the potential of being discharged into the storm drain system through being windblown or in the event of a material spill. g. Never clean machinery, equipment, tools, brushes, or rinse containers into a street, gutter, or storm drain. h. Ensure that concrete/gunite supply trucks or concrete/plaster operations do not discharge wash water into street, gutters, or storm drains. Page 27 of 30