10 - Laserfiche WebLink

Prior to the installation, the applicant/developer shall submit the design and location of the bicycle racks to the Director of Community Development for review and approval. Building and Safety Division 86. All retaining walls higher than four feet from the top of the wall to the bottom of the footway shall be constructed of reinforced concrete, masonry, or other material as approved by the Director of Community Development, or shall be an approved crib wall type. Calculations signed by a registered civil engineer shall accompany the wall plans. 87. At the time of building permit plan submittal, the project developer shall submit a final grading and drainage plan prepared by a licensed civil engineer depicting all final grades and on -site drainage control measures to prevent stormwater runoff onto adjoining properties. 88. Prior to issuance of building permits, the applicant/developer shall submit a waste management plan to the Building and Safety Division. The plan shall include the estimated composition and quantities of waste to be generated and how the project developer intends to recycle at least 75 percent of the total job site construction waste measured by weight or volume. Proof of compliance shall be provided to the Chief Building Official prior to the issuance of a final building permit. During construction, the project developer shall mark all trash disposal bins "trash materials only" and all recycling bins "recycling materials only." The project developer shall contact Pleasanton Garbage Service for the disposal of all waste from the site. Engineering Division 89. A "Conditions of Approval" checklist shall be completed and attached to all plan checks submitted for approval indicating that all conditions have been satisfied. 90. The project developer shall comply with the recommendations of the projects geotechnical consultant. The project developer's geotechnical consultant shall review and approve all foundation, retaining wall, and drainage geotechnical aspects of the final development plans to ensure that the recommendations have been properly incorporated into the project design. The consultant shall certify by writing on the plans or as otherwise acceptable to the City Engineer that the final development plan is in conformance with the geotechnical report approved for the project. 91. The project developer shall submit a final grading and drainage plan prepared by a licensed civil engineer including all supporting information and design criteria (including but not limited to any peer review comments), storm drain treatment calculations, hydromodification worksheets, all final grades and drainage control 15 of 28