05 - Laserfiche WebLink

64.A "Conditions of Approval" checklist shall be completed and attached to all plan checks submitted for approval indicating that all conditions have been satisfied. 65.The project developer shall construct vertical P.C.C. curbs and gutters within this development unless otherwise approved by the City Engineer. When the sidewalk is adjacent to the curb and gutter, they shall be poured monolithically. 66.Any damage to existing street improvements during construction on the subject property shall be repaired to the satisfaction of the City Engineer at full expense to the project developer. This shall include slurry seal, overlay, or street reconstruction if deemed warranted by the City Engineer. 67.This approval does not guarantee the availability of sufficient water and/or sewer capacity to serve the project. 68.The haul route for all materials to and from this development shall be approved by the City Engineer prior to the issuance of a permit, and shall address the need to schedule major truck trips and deliveries during off peak travel times, to avoid peak travel congestion. It shall also include the provision to monitor the street surfaces used for the haul route so that any damage and debris attributable to the haul trucks is identified and corrected at the expense of the project applicant or developer. 69.Storm drainage swales, gutters, inlets, outfalls, and channels not within the area of a dedicated public street approved by the City Engineer shall be privately maintained by the property owners or through an association approved by the City. 70.A detailed grading and drainage plan prepared by a licensed Civil Engineer including all supporting information and design criteria (including but not limited to any peer review comments), storm drain treatment calculations, hydromodification worksheets, etc., shall be submitted as part of the plan check plans submitted to the Building and Safety Division. 71.The project developer and/or the project developer's contractor(s) shall obtain an encroachment permit from the City Engineer prior to moving any construction equipment onto the site. 72.The project developer shall include erosion control measures on the final grading plan, subject to the approval of the City Engineer. The project developer is responsible for ensuring that the contractor is aware of such measures. All cut and fill slopes shall be revegetated and stabilized as soon as possible after completion of grading, in no case later than October 15. No grading shall occur between October 15 and April 15 unless approved erosion control measures are in place, subject to the approval of the City Engineer. Such measures shall be maintained until such time as a permanent landscaping is in place. PUD-85-02-02D-06M, Lexus of Pleasanton Page 10 of 23