04 - Laserfiche WebLink

68. Valve tamper and water flow shall be monitored by an approved supervising station in accordance with NFPA 72 and the California Fire Code. Fire alarm control panel and remote annunciation panel(s) shall be at location(s) approved by the Fire Prevention Bureau. All systems shall be point identified by individual device, monitored, and annunciated by device type and point. 69. Access for this project is acceptable by the Fire Marshal as currently shown on the PUD development plan. Unless otherwise approved by the Fire Marshal, the applicant/developer shall not modify the site access that deviates from the following requirements: Buildings or portions of buildings or facilities exceeding 30 feet (9144 mm) in height above the lowest level of fire department vehicle access shall be provided with approved fire apparatus access roads capable of accommodating fire department aerial apparatus. Fire apparatus access roads shall have a minimum unobstructed width of 26 feet in the immediate vicinity of any building or portion of building more than 30 feet (9144 mm) in height. At least one of the required access routes meeting this condition shall be located within a minimum of 15 feet (4572 mm) and a maximum of 30 feet (9144 mm) from the building, and shall be positioned parallel to one entire side of the building. The Access way proposed is acceptable. Provide auto turn exhibit to ensure 13-6" vertical clearance is maintained at the corners of the overhang of new Duplex Buildings A and B. Building and Safety Division 70. Unless otherwise approved by the Director of Community Development, all required adaptable dwelling units shall provide the following features: a. Install wire for both audible & visual doorbell within unit. b. Balcony/patio at same floor level as unit, within 1/2 inch, per California Building Code Section 1121A.1.. c. Windows for viewing shall have a 36" maximum sill height. d. 44" minimum hallway width and 32" minimum clear door opening width for all doorways within units. e. Lever type handles on all doors. f. An 18" minimum clear floor space beside door on pull side at latch jamb. g. All receptacle or other outlets, 18" minimum height above finished floor. h. Rocker type light switches 44"- 48" above finish floor, and thermostats 48" maximum height. i. Variable height (28"- 42") work surfaces such as cutting boards, countertops, sinks, and/or cooktops. A minimum of two 15 inch wide cutting boards at variable heights will satisfy this requirement. j. Loop handle pulls on drawers and cabinet doors or touch hardware no knobs. k. Full-extension, pull-out drawers, shelves and racks in base cabinets. I. Full height pantry storage with easy access pull-out and/or adjustable height shelves. 12 of 31