Laserfiche WebLink
D A minimum 18 -inch clear floor space beside the door on the pull side at latch jamb. <br />g) All receptacle or other outlets at a minimum height of 18 inches above the finished <br />floor. <br />h) Rocker type light switches at a maximum height varying from 40 inches to 48 <br />inches above the finished floor, and thermostats at a maximum height of 48 inches <br />above the finished floor. <br />i) Variable height work surfaces, such as cutting boards, countertops, sinks, and /or <br />cook tops at a height varying from 28 inches to 42 inches above the finished floor. <br />j) Loop handle pulls on drawers and cabinet doors or touch hardware with no knobs. <br />k) Full- extension, pull -out drawers, shelves and racks in base cabinets. <br />1) Full height pantry storage with easy access pull -out and /or adjustable height <br />shelves. <br />m) Front - mounted controls on all appliances. <br />n) Adjustable height closet rods and shelves. <br />o) Single -lever water controls at all plumbing fixtures and faucets. <br />P) Hand- held adjustable shower head. <br />q) Blocking in walls around toilet, tub, and shower for future placement and relocation <br />of grab bars. <br />157. The project applicant/developer shall submit plot plans for each of the single - family home <br />lots showing building setbacks and a topographic plan showing grading and drainage. <br />Pad elevations, finish floor elevations, retaining walls, easements, and maximum height of <br />the highest structure are to be indicated on the plan. The plans for the lots are to be <br />signed by a registered civil engineer. All residential plot plans shall show compliance with <br />2907(d) and 70012(d) of the Uniform Building Code. <br />STANDARD CONDITIONS OF APPROVAL <br />Building <br />158. All retaining walls higher than four feet from the top of the wall to the bottom of the <br />footway shall be constructed of reinforced concrete, masonry, or other material as <br />approved by the Director of Community Development, or shall be an approved crib wall <br />type. Calculations signed by a registered civil engineer shall accompany the wall plans. <br />159. At the time of building permit plan submittal, the project developer shall submit a final <br />grading and drainage plan prepared by a licensed civil engineer depicting all final grades <br />and on -site drainage control measures to prevent storm water runoff onto adjoining <br />properties. <br />Page 30 <br />