06 - Laserfiche WebLink

The project developer shall include erosion control/stormwater quality measures on the project grading plan which shall specifically address measures to prevent soil, dirt, and debris from entering the public storm drain system. Such measures may inc ude, but are not limited to, hydroseeding, hay bales, sandbags, ancl siltation fences and shall be subject to the review and approval of the City Engineer/Chief Building Official. If no grading plan is required, necessary erosion control/stormwater quality measures shall be shown on the site plan submitted for a building permit, and shall be subject to the review and approval of the Building and Safety Division. The project developer is responsible for ensuring that the contractor is aware of and implements such measuies. ii. All cut and fill slopes shall be revegetated and stabilized after completion of grading, but in no case later than October 15. Hydroseeding shall be accomplished before September 15 and irrigated with a temporary irrigation system to ensure that the vegetated areas are established before October 15. No grading shall occur between October 15 and April 15 Lnless approved erosion control/stormwater quality measures are in place, subject to the approval of City Engineer/Chief Building Official. Such measures shall be maintained until such time as permanent landscaping is place. iii. Gather all sorted construction debris on a regular basis and place them in the appropriate container for recycling to be emptied at least on a weekly basis. When appropriate, use tarps on the ground to collect fallen debris or splatters that could contribute to stormwater runoff pollution. iv. Remove all dirt, gravel, rubbish, refuse, and green waste from the street pavement and storm drains adjoining the site. Limit construction access routes onto the site and place gravel on them. Do not drive vehicles and equipment off paved or graveled areas during wet weather. Broom sweep the street pavement adjoining the project site on a daily basis. Scrape caked on mud and dirt from these areas before sweeping. v. Install filter materials (such as sandbags, filter fabric, etc.) at the storm drain inlet nearest the downstream side of the project site in order to retain any debris or dirt flowing in the storm drain system. Maintain and/or replace filter materials to ensure effectiveness and to prevent street flooding. vi. Create a contained and covered area on the site for the storage of cement, paints, oils, fertilizers, pesticides, or other materials used PUD-87, Auf der Maur/ Rickenbach /Vintage City Council Page 37 of 39