ORD 2009 - Laserfiche WebLink

f. Building and situs plans are to be submitted to the Building and Safety Division on a computer disk in a format approved by the Chief Building Official. Digitized information will be submitted before requesting a final inspection and should reflect as built situs and architectural information as approved by the Chief Building Official. g. Prior to receiving a foundation inspection, a pad elevation certification prepared by a licensed land surveyor or registered civil engineer will be submitted to the Chief Building Official, certifying that the pad elevations and building location (setbacks) are pursuant to the approved plans. h. A final utility plan showing the proposed sewer system, waver supply, storm drainage, electric power distribution, gas distribution, communication service, cable television, and any required alarm system for the site will be submitted. Said plan will be subject to the review and approval of the City Engineer prior to the issuance of any building permits. 3. Geotechnical Report. Detailed geotechnical engineering studies specific to the Neighborhood Park will be submitted to the City Engineer for review and approval prior to the issuance of a building permit. A corrosion specialist will be hired to conduct further tests of the soils and provide site development recommendations. The studies will also address: 1) the minimum required slope needed for the curb and gutter to maintain drainage flow; 2) recommendations for saturated soils adjacent to the roadway and curb sections; and 3) and whether or not rebar should be placed in concrete curbs, sidewalks, etc. 4. Mechanical Equipment and Transformers. a. The location of any pad mounted transformers will be subject to approval of the Director of Parks and Community Services and the Engineering Division, prior to issuance of permits by the Building and Safety Division. Such transformers will be screened by landscaping. All transformers will be shown on the plans submitted for issuance of building permits. Transformers will be located at the rear of the site if feasible. Pad mounted transformers will not be installed in a PSE. b. All backflow prevention devices, above ground irrigation controls, and above ground irrigation meters will be located and screened so as to minimize visual impacts. The location of all backflow prevention devices, above ground irrigation controls, and above ground irrigation meters and the quantity and type of proposed landscape screening will be subject to the review and approval of the Director of Parks and Community Services and City Engineer prior to the issuance of a building permit. 5. Water and Sewer Utilities. a. The public water line main will be a minimum of 12 inches in diameter unless otherwise approved by the City Engineer. Conditions of Approval/PUD-80 Page 4 of 25