Laserfiche WebLink
Metadata
Document management portal powered by Laserfiche WebLink 9 © 1998-2015 Laserfiche. All rights reserved.
b. Gather all sorted construction debris on a regular basis and place it in the appropriate <br /> container for recycling; to be emptied at least on a weekly basis. When appropriate, use <br /> tarps on the ground to collect fallen debris or splatters that could contribute to stormwater <br /> runoff pollution. <br /> c. Remove all dirt, gravel, rubbish, refuse, and green waste from the street pavement and storm <br /> drains adjoining the site. Limit construction access routes onto the site and place gravel on <br /> them. Do not drive vehicles and equipment off paved or graveled areas during wet weather. <br /> Broom sweep the street pavement adjoining the project site on a daily basis. Scrape caked- <br /> on mud and dirt from these areas before sweeping. <br /> d. Install filter materials (such as sandbags, filter fabric, etc.) at the storm drain inlet nearest the <br /> downstream side of the project site in order to retain any debris or dirt flowing in the storm <br /> drain system. Maintain and/or replace filter materials to ensure effectiveness and to prevent <br /> street flooding. <br /> e. Create a contained and covered area on the site for the storage of cement, paints, oils, <br /> fertilizers, pesticides, or other materials used on the site that have the potential of being <br /> discharged into the storm drain system through being windblown or in the event of a material <br /> spill. <br /> f. Never clean machinery, equipment, tools, brushes, or rinse containers into a street, gutter, or <br /> storm drain. <br /> g. Ensure that concrete/gunite supply trucks or concrete/plaster operations do not discharge <br /> wash water into street, gutters, or storm drains. <br /> C. Operation Requirements <br /> The Permit's operation and maintenance requirements include but are not limited to the following: <br /> The operation and maintenance of treatment measures including but not limited to bio-swales, <br /> lawns, landscaped areas with deep-rooted plants, oil/water separator, filterra units, etc., requires <br /> completing, signing and recording an agreement with Alameda County recorder's office in a <br /> format approved by the State and Alameda County. <br /> CODE REQUIREMENTS <br /> (Applicants/Developers are responsible for complying with all applicable Federal, State and City codes <br /> and regulations regardless of whether or not the requirements are part of this list. The following items are <br /> provided for the purpose of highlighting key requirements.) <br /> Planning <br /> 85. The permit plan check package will be accepted for submittal only after the ordinance approving the <br /> PUD development plan becomes effective, unless the project developer submits a signed statement <br /> acknowledging that the plan check fees may be forfeited in the event that the ordinance is overturned <br /> or that the design is significantly changed. In no case will a permit be issued prior to the effective <br /> date of the ordinance. <br /> Building <br /> 86. The project applicant shall submit a building survey and/or record of survey and a site development <br /> plan in accordance with the provisions of Chapter 18.68 of the Municipal Code of the City of <br /> Pleasanton. These plans shall be approved by the Chief Building and Safety Official prior to the <br /> issuance of a building permit. The site development plan shall include all required information to <br /> design and construct site, grading, paving, drainage, and utilities. <br /> Ordinance No. 2024 <br /> Exhibit A-1 Page 11 of 12 <br />