11 ATTACHMENTS 6 TO 13 - Laserfiche WebLink

• For buildings less than 10,000 square feet, testing and adjusting of systems is required before a new space- conditioning system serving a building or space is operated for normal use. 5.410.4 1. After completion of testing, adjusting and balancing, provide a final report of testing signed by the individual responsible for performing these services. 5.410.4.4 2. Provide the building owner with detailed operating and maintenance instructions and copies of guaranties /warranties for each system prior to final inspection. 5.410.4.5 3. Include a copy of all inspection verifications and reports required by the enforcing agency. 5.410.4.5.1 • Comply with at least one additional elective from Division A5.4. ENVIRONMENTAL QUALITY o Install only a direct -vent sealed- combustion gas or sealed wood - burning fireplace or a sealed woodstove and refer to residential requirements in the California Energy Code. 5.503.1 o Woodstoves shall comply with US EPA Phase II emission limits. 5.503.1.1 • At the time of rough installation or during storage on the construction site and until final startup of the heating and cooling equipment, all duct and other related air distribution component openings shall be covered with tape, plastic, sheetmetal or other methods acceptable to the enforcing agency to reduce the amount of dust or debris which may collect in the system. 5.504.3 • Adhesives and sealants used on the project shall meet the requirements of the following standards. 1. Adhesives, adhesive bonding primers, adhesive primers, sealants, sealant primers and caulks shall comply with local or regional air pollution control or air quality management district rules, or SCAQMD Rule 1168 VOC limits. 5.504.4.1 2. Aerosol adhesives and smaller unit sizes of adhesives and sealant or caulking compounds On units of product, less packaging, which do not weigh more than one pound and do not consist of more than 16 fluid ounces) shall comply with statewide VOC standards. 5.504.4.1 • Architectural paints and coatings shall comply with Table 5.504.4. 5.504.4.3 • Aerosol paints and coatings shall meet the Product - Weighted MIR Limits for ROC in Section 94522(a)(3) and other requirements, including prohibitions on use of certain toxic compounds and ozone depleting substances (CCR, Title 17, Section 94520 et seq). 5.504.4.3.1 • All carpet cushion installed in the building interior shall meet the requirements of the Carpet and Rug Institute (CRI) Green Label program. 5.504.4.4.1 • All carpet adhesive shall meet the requirements of Table 804.4.1. 5.504.4.4.2 • Hardwood plywood, particleboard and medium density fiberboard composite wood products used on the interior or exterior of the building shall meet the requirements for formaldehyde as specified in Table 5.504.4. 5.504.4.5 • Composite wood products shall meet the Phase 2 requirements before the compliance dates indicated in Table 5.504.4.5. A5.504.4.5.1 • For at least 80 percent of floor area receiving resilient flooring, install resilient flooring complying with the VOC- emission limits defined in the 2009 CHPS criteria and listed on its Low - emitting Materials List (or Product Registry) or certified under the FloorScore program of the Resilient Floor Covering Institute. A5.504.4.7 • Thermal Insulation must comply with the VOC- emission limits defined in 2009 CHPS criteria and listed on its Low- emitting Materials List. A5.504.4.8 • In mechanically ventilated buildings, provide regularly occupied areas of the building with air filtration media for outside and return air prior to occupancy that provides at least a MERV of 8. 5.504.5.3 • Prohibit smoking within 25 feet of building entries, outdoor air intakes and operable windows where outdoor areas are provided for smoking and in buildings. 5.504.7 • Wall and floor - ceiling assemblies making up the building envelope shall have an STC of at least 50 and exterior windows shall have a minimum STC of 30 whenever within 1,000 feet of a freeway right - Note: This general informational handout is provided as a courtesy. Specific questions should be addressed to the project architect, contractor, other design professional, or by more detailed consideration of Pleasanton Municipal Code Chapter 20.26 and the California Green Building Standards Code (CALGreen 2010) at Title 24 Cal. Code of Regulations, Part 11.