07 - Laserfiche WebLink

Engineer at full expense to the developer. This shall include slurry seal, overlay, or street reconstruction if deemed warranted by the City Engineer. 7. Phasing. Phase I— Infrastructure Improvements for the Staples Ranch Site. Prior to occupancy of any building on site: a. The stormwater flow control basin in the Neighborhood Park shall be constructed and operational as determined by the City Engineer. b. The Stoneridge Drive extension from Trevor Parkway to El Charro Road shall be constructed and operational, as determined by the City Engineer. c. The ACSPA shall replace the existing eight -inch water line in Staples Ranch Drive between Vermont place and the senior continuing care community site (PUD -68) site with a new 12 -inch water line. Prior to occupancy, the ACSPA shall reconnect all existing house water service connections along Staples Ranch Drive to this new water main. The location of the new line, and the timing of the connections shall be subject to the review and approval of the City Engineer. d. All public water and sewer lines loops on the PUD site shall be installed. All necessary public water and sewer line loops shall be installed as determined by the City Engineer. e. All emergency vehicle access (EVA) connection points shall have a knox box, as determined by the Fire Marshal. f. An access easement shall be provided to Zone 7 and the City of Pleasanton allowing for maintenance equipment to access the Arroyo Mocho. The easement shall be located generally as shown on Exhibit B for Case PUD -68 and shall be redesigned to be wide enough to accommodate the largest pieces of maintenance equipment anticipated to be used in the Arroyo Mocho. The applicant shall use AutoTurn or similar software approved by the City Engineer to determine how wide the easement should be. The final location, width, and design of the easement shall be subject to the review and approval of Zone 7 and the City Engineer. g. All street landscaping and public sidewalks required as part of the PUD. 8. Trash and Recycling Enclosures. All trash and recycling refuse shall be contained completely within the approved trash and recycling enclosure. The materials and color of the enclosure shall match the building and the gates shall be corrugated metal or solid wood. The design of the enclosure (all four sides) shall be shown on the plans submitted for issuance of building permits. The design and location of the trash and recycling enclosure shall be subject to the approval of the Director of Community Development, the Chief Building Official, and Fire Chief. Trash and recycling containers shall be stored within the Conditions of Approval /PUD -57 General Conditions 7