PC 2001-26 - Laserfiche WebLink

Resolution No. PC-01-26 Page 15 project developer is responsible for ensuring that the contractor is aware of and implements such measures. 94. The project developer is responsible for implementing the following measures during ail construction phases of the subject project: a. Gather all construction debris on a regular basis and place them in a dumpster or other container which is emptied or removed on a weekly basis. When appropriate, use tarps on the ground to collect failen debris or splatters that could contribute to storm water pollution. b. Remove all dirt, gravel, rubbish, refuse, and green waste from the street pavement, and storm drains adjoining the project site. During wet weather avoid driving vehicles off paved areas. c. Broom sweep the public street pavement adjoining the project site on a daily basis. Caked-on mud or dirt shall be scraped from these areas before sweeping. d. Install filter materials (such as sandbags, filter fabric, etc.) at the storm drain inlet nearest the downstream side of the project site in order to retain any debris or dirt flowing into the City storm drain system. Filter materiais shall be maintained and/or replaced as necessary to ensure effectiveness and to prevent street flooding. Dispose of filter particles in the trash. e. Create a contained and covered area on the site for the storage of bags, cement, paints, flammable, oils, fertilizers, pesticides, or any other materials used on the project site that have the potential for being discharged to the storm drain system through being windblown or in the event of a material spill. f. Never clean machinery, tools, brushes, etc., or rinse containers into a street, gutter, or storm drain. g. Ensure that concrete/gunite supply trucks or concrete/plasterers operations do not discharge wash water into street gutters or drains. h. Construction access routes shail be limited to those approved by the City Engineer or Building Inspector and shall be shown on the approved grading plan.