PC 2001-22 - Laserfiche WebLink

61. All retaining walls higher than four feet (4' 0") from the top of the wall to the bottom of the footway shall be constructed of reinforced concrete or shall be an approved crib wall type. Calculations signed by a registered civil engineer shall accompany the wall plans. 62. The project developer shall submit plot plans for each of the residential lots showing building setbacks and a topographic plan showing grading and drainage. Pad elevations, finish floor elevations, retaining walls, easements, maximum height of the highest structure, and the front, rear, and side yards are to be indicated on the plan. Plans for custom lots are to be signed by a registered civil engineer. All residential plot plans shall show compliance with Sections2907(d) and 70012(d) of the Uniform Building Code. 63. The project developer shall submit two (2) copies of the site soils report to the Director of Building Inspection for third party peer review and shall pay for such review at the time specified by the Director, but in all cases before the issuance of a grading permit. 64. The project developer shall submit record tract grading plans showing: the elevation of all four (4) corners of the lot as well as the center of the lot; all top and toe of slope elevations, and the top and toe of all retaining wall elevations. 65. The record grading plan is to be submitted to the Director of Building Inspection before the first house final. 66. The soils engineer shall certify the pad compactions of all lots containing fill to the satisfaction of the Director of Building Inspection prior to the issuance of building permits. 67. Building and situs plans are to be submitted to the Building Department on computer disk in a format approved by the Director. Digitized information shall be submitted before requesting a final inspection and should reflect as-built situs and architectural information as approved by the Director. Conditions of Approval, PUD-5, Centex Homes' Apperson Ridge May 9, 2001 Page 22