ORD 1693 - Laserfiche WebLink

designated for abandonment or any wells, encountered during construction, are to be destroyed in accordance with a permit obtained from Zone 7. 65. All existing septic tanks or holding tanks shall be removed or sealed, filled, and abandoned, pursuant to the requirements of the Alameda County Department of Health Services. 66. The developer's contractor(s) shall obtain an encroachment permit from the City Engineer prior to moving any construction equipment onto the site. 67. Any damage to existing street improvements during construction on the subject property shall be repaired to the satisfaction of the City Engineer at full expense to the developer. This shall include slurry seal, overlay, or street reconstruction if deemed warranted by the City Engineer. 68. The haul route for all materials to and from this development shall be approved by the City Engineer prior to the issuance of an encroachment permit. 69. The applicant shall submit a construction Best Management Practices (BMP's) program for review and approval by the Planning Director prior to issuance of building and/or grading permits. These BMP's shall be implemented by the general contractor and all subcontractors and suppliers of materials and equipment. Construction site cleanup and control of construction debris shall also be addressed. Failure to comply with the approved construction BMP may result in the issuance of correction notices, citations, or a stop work order. 70. The applicant is responsible for implementing the following measures during all construction phases of the project: a. Gather all construction debris on a regular basis and place it in a dumpster or other container which is emptied or removed an a weekly basis. When appropriate, use tarps on the ground to collect fallen debris or splatters that could contribute to storm water runoff pollution. b. Remove all dirt, gravel, rubbish, refuse, and green waste from the street pavement and storm drains adjoining the site. Limit construction access routes onto the site and place gravel on them. Do not drive vehicles and equipment off paved or graveled areas during wet weather. Broom sweep the street pavement adjoining the project site on a daily basis. Scrape caked-on mud and dirt from these areas before sweeping. c. Install filter materials (such as sandbags, filter fabric, etc.) at the storm drain inlet nearest the downstream side of the project site in order to retain any debris or dirt flowing in the storm drain system. Maintain and/or replace filter materials to ensure effectiveness and to prevent street flooding. Conditions of Approval -- PUD-96-13 Page 11