PC 2000-60 - Laserfiche WebLink

Resolution No. PC-00-60 Page 10 49. 50. 51. 52. 53. The project developer's contractor(s) shall obtain an encroachment permit from the City Engineer prior to moving any construction equipment onto the site. The project developer shall install Fossil Filters or approved equals in the parking lot to intercept and pretreat storm water prior to reaching the storm drain. The design, locations, and a schedule for maintaining the filters shall be submitted to the City Engineer for review and approval prior to issuance of building permits. The Fossil Filters shall be cleaned at least twice a year: once immediately prior to October 15 and once in January. The project developer shall enter into a maintenance agreement for the oil/water separator. The project developer shall sweep or vacuum the parking lot and sidewalks a minimum of once a month and shall prevent the accumulation of litter and debris on the site. Comers and hard to reach areas shall be swept manually. If sidewalks and/or the parking lot are pressure washed, debris must be trapped and collected to prevent entry into the storm drain system. No cleaning agent may be discharged into the storm drain. If any cleaning agent or degreaser is used, wash water must be collected and discharged to the sanitary sewer, subject to approval of the Dublin-San Ramon Services District (DSRSD). The project developer shall label ail on-site storm drain inlets with the wording, "No Dumping -- Drains to Bay" using City-approved methods and materials. On- site storm drain facilities shall be cleaned a minimum of twice a year as follows: immediately prior to October 15 and once in January. Additional cleaning may be required if found necessary by the City Engineer/Director of Building Inspection.. The project developer shall submit a construction Best Management Practices (BMP's) program for review and approval by the Planning Director prior to issuance of building and/or grading permits. These BMP's shall be implemented by the general contractor and all subcontractors and suppliers of materials and equipment. Construction site cleanup and control of construction debris shall also be addressed. Failure to comply with the approved eoustmction BMP may result in the issuance of correction notices, citations, or a stop work order. The project developer is responsible for implementing the following measures during ail construction phases of the project: Gather all construction debris on a regular basis and place it in a dumpster or other container which is emptied or removed on a weekly basis. When appropriate, use tarps on the ground to collect fallen debris or splatters that could contribute to storm water runoffpollution. Remove all dirt, gravel, rubbish, refuse, and green waste from the street pavement and storm drains adjoining the site. Limit construction access routes onto the site and place gravel on them. Do not drive vehicles and equipment off paved or graveled areas during wet weather. Broom sweep the street pavement adjoining the project site on a daily basis. Scrape caked-on mud and dirt from these areas before sweeping.