PC 2000-54 - Laserfiche WebLink

Resolution No. PC-00-54 Page 12 by the general contractor and all subcontractors and suppliers of materials and equipment. Construction site cleanup and control of construction debris shall also be addressed. Failure to comply with the approved construction BMP may result in the issuance of correction notices, citations, or a stop work order. The project developer is responsible for implementing the following measures during all construction phases of the project: Gather all construction debris on a regular basis and place it in a dumpster or other container which is emptied or removed an a weekly basis. When appropriate, use tarps on the ground to collect fallen debris or splatters that could contribute to storm water runoffpollution. Remove all dirt, gravel, rubbish, refuse, and green waste from the street pavement and storm drains adjoining the site. Limit construction access routes onto the site and place gravel on them. Do not drive vehicles and equipment off paved or graveled areas during wet weather. Broom sweep the street pavement adjoining the project site on a dally basis. Scrape caked-on mud and dirt from these areas before sweeping. Co Install filter materials (such as sandbags, filter fabric, etc.) at the storm drain inlet nearest the downstream side of the project site in order to retain any debris or dirt flowing in the storm drain system. Maintain and/or replace filter materials to ensure effectiveness and to prevent street flooding. Create a contained and covered area on the site for the storage of bags, cement, paints, oils, fertilizers, pesticides, or other materials used on the site that have the potential of being discharged into the storm drain system through being windblown or in the event of a material spill. e. Never clean machinery, equipment, tools, brushes, or rinse containers into a street, gutter, or storm drain. Ensure that concrete/gunite supply tracks or concrete/plaster operations do not discharge wash water into street, gutters, or storm drains.