PC 2000-32 - Laserfiche WebLink

Resolution No. PC-00-32 Page 11 Engineering Requirements: 57. All utilities required to serve any existing or proposed development on-site shall be installed underground. 58. The paving sections for the on-site parking and drive areas shall be designed on the basis of an R-Value test and a traffic index to carry the anticipated traffic loads. This design shall be subject to the approval of the Director of Building Inspection. The minimum paving section shall be two inches (2") of asphalt concrete (A.C.) on a six inch (6") asphalt base (A.B.). The minimum A.C. pavement slope shall be one pereem (1%). For pavement slopes less than 1%, the surface runoff shall be carried in a concrete gutter to an acceptable point of discharge. The minimum slope for concrete gutter shall be 0.5%. 59. The project developer shall submit a final grading and drainage plan prepared by a licensed civil engineer depicting all final grades and on-site drainage control measures, including concrete-lined V-ditcbes, to protect all cut and fill slopes from surface water overflow. This plan shall be subject to the review and approval of the City Engineer and the Director of Building Inspection prior to the issuance of any building permits. 60. The project developer shall submit a refundable cash bond for ba?ard and erosion control prior to issuance of an Engineering or Building Department pemait. The amount of this bond will be determined by the City Engineer. 61. The project developer shall grant an easement to the City over those parcels needed for public service easements (P.S.E.) and which are approved by the City Engineer or other easements which may be designated by the City Engineer. 62. The project developer shall construct vertical P.C.C. curbs and gutters within this development unless othenvise approved by the City Engineer. When the sidewalk is adjacent to the curb and gutter, they shall be poured monolithically. 63. The haul route for all materials to and from this development shall be approved by the City Engineer prior to the issuance of an encroachment permit. The project developer shall include erosion control measures on the final grading plan, subject to the approval of the City Engineer. The project developer is responsible for ensuring that the contractor is aware of such measures. All cut and fill slopes shall be revegetated and stabilized as soon as possible after completion of grading, in no case later than October 15. No grading shall occur between October 15 and April 15 unless approved erosion control measures are in place, subject to the approval of the Building Depmhnent. Such measures shall be maintained until such time as permanent landscaping is in place. 65. The project developer shall submit a dust control plan or procedure as part of the improvement plans.